set and forget method question

[miket6]

when just set and forget method is used do you still run gas through the "out" line or do you just place fitting on the correct towers as if you were to serve

[*****]

Excellent question Mike, I was going to ask this on your other post. I am yet to perfect the method, yet I hear that many people put the gas onto the beer out connection, allowing the gas to bubble up through the beer. Some say that the gas connection fits okay on the beer post while others change the gas tube over to the beer connection. My gas connector fitted the beer post and on my last keg I ran gas in this way for about a week then swapped over to gas onto the gas post for another 5 weeks. Pulled a few beers during the week and the results are better just inconsistent and maybe this is my pouring method.

I am very keen to hear how Graham makes his connections for set and forget carbonation

[Guest]

See my answer to this in the other post. Stuffed if I am going to repeat it here. No need to run 2 of the same posts imo.

 

@ Scott - who is Wayne?... I didn't see any such method mentioned.